Raymarine St60 Wind Service Manual
View and Download Raymarine ST60+ owner's handbook manual online. Club House Wind Instrument. ST60+ Marine Equipment pdf manual download.
• ST60+ Club House Wind Instrument Owner’s Handbook Document reference: 81267-1 Date: December 2005. • Raymarine, ST60+ and SeaTalk are trademarks of Raymarine UK Limited © Handbook contents copyright Raymarine UK Limited 2005.
• Handbook information To the best of our knowledge, the information in this handbook was correct when it went to press. However, Raymarine cannot accept liability for any inaccuracies or omissions it may contain. In addition, our policy of continuous product improvement may change specifications without notice. • The WEEE Directive requires the recycling of waste electrical and electronic equipment. Whilst the WEEE Directive does not apply to some of Raymarine's products, we support its policy and ask you to be aware of how to dispose of this product.
• Preface Contents Preface Important information. I Safety notices.
I WARNING: Product installation & operation. I WARNING: Electrical safety. 
I WARNING: Instrument usage. I EMC conformance. I Handbook information. I Product disposal.
Iii Introduction. • Suppression ferrites. 9 Connections to other equipment. 10 2.2 Installation procedure.10 CAUTION: Maintain structural safety.10 Unpacking.10 Fitting the instruments.10 Surface mounting. 11 Flush Mounting. 12 CAUTION: Use the correct screws.13 Bracket Mounting Kit. 14 Connections at the instrument.15 Power supply connections.
• Thank you for purchasing a Raymarine product. We are sure your ST60+ instrument will give you many years of trouble-free operation. This handbook describes how to install and use the Raymarine ST60+ Club House Wind instrument, which is intended for use ashore (e.g. In clubhouses or homes) to show local wind conditions.
• Parts supplied Unpack your ST60+ instrument and check that the following items are present: • Item 1, ST60+ Club House Wind instrument, fitted with standard bezel for sur- face mounting. • Item 2, Fixing studs (2). • Item 3, Thumb nuts (2). • Chapter 1: Operation & Maintenance 1.1 Getting started This handbook describes how to operate, maintain and install the Raymarine ST60+ Club House Wind instrument. This instrument shows the wind speed and direction.
CAUTION: Calibration requirement To ensure this product performs at its best, you MUST calibrate it. • Digital display The digital display normally shows the wind speed in either knots or meters per second.
You can use the operation flow chart), displayed as follows: • Beaufort wind speed. • Maximum wind speed. • Maximum wind speed alarm. • Chapter 1: Operation & Maintenance Maximum wind speed The maximum wind speed is reset at power up and can also be reset manually by pressing the > button for 3 seconds. Wind speed alarms An alarm condition occurs when the wind speed either exceeds the maximum wind speed alarm level or falls below the minimum wind speed alarm level. • 1.3 Maintenance Servicing and safety • Raymarine equipment should be serviced only by authorized Raymarine ser- vice technicians.
How To Calibrate Raymarine St60 Wind
They will ensure that service procedures and replacement parts used will not affect performance. There are no user serviceable parts in any Raymarine product. • Please visit the Customer Support area of our web site at: www.raymarine.com As well as providing a comprehensive Frequently Asked Questions section and servicing information, the web site gives e-mail access to the Raymarine Technical Support Department and a details of the locations of Raymarine agents, worldwide. • Help us to help you When requesting service, please quote the following product information: • Equipment type. • Model number.
• Serial number. • Software issue number. To find out the software version number of your ST60+ Club House Wind instrument: 1. • Wind Vane transducer. The transducer is connected to the rear of the instrument.
Raymarine St60
For advice, or further information regarding the installation of this equipment, please contact the Raymarine Product Support Department or your own National Distributor. 2.1 Planning your installation.
• There must also be a viable route for the transducer cable to be routed to the instrument. As you will need to manually rotate the Wine Vane as part of the linearization pro- Note: cedure, do not actually fit it in position yet. Instrument CAUTION: Keep the rear of the instrument dry Keep the rear of instrument dry. • • Raymarine specified cables are used. Cutting and rejoining these cables can compromise EMC performance and must be avoided unless doing so is detailed in the installation manual. • Connections to other equipment If your Raymarine equipment is to be connected to other equipment using a cable not supplied by Raymarine, a suppression ferrite MUST always be attached to the cable near the Raymarine unit.